The Ditel Micra-M device calibration with the pressure sensors were little bit hard. I had to check each and every point regarding the signal it outputs. After manually selecting the required points using the calibrating device which has a wheel and a meter using which I could give known pressures to the sensor, the data was noted for later use (That is the main purpose of the task)
So 100 bar, 200 bar, 350 bar, 500 bar, 700 bar, 1400 bar pressure sensors were used to the calibration.
Using another device called DaqPRO, the values or the analog output can be calibrated to recieve data on a computer. So it was also done at the same time.
Thw whole day I had to play with the device so in the evening had a little bit ache in the eyes. Now it feels good. :)
0 comments:
Post a Comment